Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Gillette, WY

Broken Garage Door Spring Repair in Gillette, WY

Fast replacement of broken torsion or extension springs, sized to your door's weight. Typical cost $200-$450.

From the first phone call to the final safety test, broken garage door spring repair in Gillette, WY follows a simple process: diagnose, quote, repair, test. Fast replacement of broken torsion or extension springs, sized to your door's weight.

Safety first: springs and cables hold hundreds of pounds of tension. Don't try to adjust or remove them yourself, and don't run the opener on a door that's crooked or has a broken spring.

Is it time for broken garage door spring repair?

  • A loud bang from the garage, like a gunshot
  • A visible gap in the coils of the spring above the door
  • The door feels extremely heavy or won't lift more than a few inches
  • The opener strains, hums or the door reverses right away
  • Cables hanging loose from the drums

Common causes

  • Springs reaching the end of their cycle life (usually about 10,000 cycles)
  • Rust on the coils, which adds friction and stress
  • Springs that were the wrong size for the door
  • Cold weather making worn steel more brittle

What you can check yourself

  • Don't use the opener. It can strip gears or pull the door off track.
  • Don't try to lift the door by hand. Without a working spring it may weigh 130 to 250 pounds or more.
  • Look, but don't touch: a broken torsion spring shows a clear gap in the coils.
  • Keep the door closed and keep children and pets away from it.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

Our broken garage door spring repair process

  1. Secure the door and safely unwind any remaining spring tension
  2. Weigh and measure the door to size the new springs correctly
  3. Install new springs (we recommend replacing both on a two-spring door)
  4. Wind, set and balance the door so it stays put halfway up
  5. Test the opener's force and auto-reverse settings

Broken Garage Door Spring Repair cost in Gillette, WY

$200-$450Typical range, parts & labor
1-2 hoursTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Serving Gillette, WY and nearby towns

In Wyoming, cold mornings after mild afternoons put the most stress on worn springs, so breaks are common in late fall and winter.

Technicians serve all of Gillette (ZIP codes 82716 and 82717), plus Buffalo (59.3 mi), Newcastle (71.1 mi), Sheridan (79.7 mi) and North Spearfish, SD (80.9 mi). Call (833) 435-8883 to book a visit in Gillette.

Broken Garage Door Spring Repair: frequently asked questions

How much does broken garage door spring repair cost in Gillette, WY?

Broken Garage Door Spring Repair typically costs $200-$450 including parts and labor, and usually takes 1-2 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do broken garage door spring repair the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is broken garage door spring repair covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Wyoming or Gillette requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Gillette, WY

LiftMaster Opener Circuit Board Replacement

LiftMaster is the professional-installer brand of The Chamberlain Group. The color of the learn button on the motor unit shows which remotes are compatible (yellow on Security+ 2.0 models; purple, red, orange or green on older ones), and most current models work with the myQ app.

Typical $175-$400

Richards-Wilcox Garage Door Roller Replacement

Worn steel or plastic rollers swapped for quiet, sealed nylon rollers.

Typical $150-$350

Holmes Garage Door Off-Track Garage Door Repair

Doors that have come off their tracks secured, re-hung and realigned.

Typical $175-$450

Wayne Dalton Garage Door Track Repair

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $150-$400

Allstar Garage Door Opener Repair

Allstar openers are no longer made. Replacement remotes and many parts are still available, and we'll tell you when replacing the opener makes more sense.

Typical $125-$350

Overhead Door Garage Door Repair

Overhead Door traces its roots to C.G. Johnson, who invented the upward-acting garage door in 1921. The company builds residential and commercial doors and openers.

Typical $150-$450

Clopay Off-Track Garage Door Repair

Clopay is one of the largest residential garage door makers in North America, with lines such as Classic, Modern Steel, Coachman and Canyon Ridge. The model is usually printed on a label on the door's end stile, which helps us match replacement panels.

Typical $175-$450

Wayne Dalton Garage Door Roller Replacement

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $150-$350

Chamberlain Remote & Keypad Programming

Chamberlain is the retail line of The Chamberlain Group, sold at home centers. It uses the same Security+ 2.0 remote technology and myQ app as LiftMaster, so many accessories work with both brands.

Typical $50-$150

Raynor Garage Door Track Repair

Raynor, based in Dixon, Illinois, makes residential and commercial garage doors as well as openers.

Typical $150-$400

Overhead Door Garage Door Panel Replacement

Overhead Door traces its roots to C.G. Johnson, who invented the upward-acting garage door in 1921. The company builds residential and commercial doors and openers.

Typical $300-$900

Hörmann Opener Circuit Board Replacement

Failed logic boards and receivers replaced, often after a power surge.

Typical $175-$400

Garage door stuck, noisy or broken?

Talk to a garage door technician in Gillette, WY now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote